Zprobe Questions

I've been looking for a better z probe for my printer. The mechanical endstop in my current delta set up takes forever to tune and looses repeatability after each time I auto calibrate.

So far I've found these: https://miscsolutions.wordpress.com/mini-height-sensor-board/

and

http://www.filafarm.de/collections/elektronik/products/reflex-optischer-endstop

I'm wondering if anyone has any experience with either? The mini height sensor board seems pretty well documented and I'm pretty sold on it but any info on best sensor for repeatability would be awesome!

submitted by /u/warbunnies
[link] [comments]
Source: New feed

Leave a Reply

Your email address will not be published. Required fields are marked *